Nortel-networks Passport 8002PS Manuale Utente

Part No. 207314-BApril 20004401 Great America ParkwaySanta Clara, CA 95054Installing the Passport 8002PS DC Power Supply

6 Removing a Power SupplyRequired tools: Phillips screwdriver, 7/16-inch wrenchIn a chassis with a redundant power supply configuration, you can repla

75. Loosen the retaining screws on the power supply.6. Lift the extractor lever to disconnect the power supply from the backplane connector.Slide the

8 9. Slide the power supply all the way out of the chassis, and set it aside.10. Install a replacement power supply following the instructions earlier

ii Copyright © 2000 Nortel NetworksAll rights reserved. April 2000.The information in this document is subject to change without notice. The statement

iiiJapan/Nippon Requirements OnlyVoluntary Control Council for Interference (VCCI) StatementTaiwan RequirementsBureau of Standards, Metrology and Insp

iv

1About This GuideThis guide provides the following information:• Safety and environmental guidelines for the power supply (this page)• Instructions fo

2 Preparing CablesRequired tools: Crimping tool for crimping lugs onto cables; heat gunNortel Networks does not supply the cables for connecting the P

3Operational NotesA Passport 8000 Series Chassis with up to five installed modules can operate with one installed power supply. For a redundant power

4 3. Push the power supply partway into the bay. Leave the terminal block at the side of the power supply exposed.9412FANote: If you are installing a

56. Attach the grounding cable to the system or rack ground for your DC input power source.7. Firmly slide the power supply all the way into the bay a